Setting Up the BWSE Plug-in for SmartMapper Application

Copyright © Cloud Software Group, Inc. All Rights Reserved

Chapter 3 Working with TIBCO ActiveMatrix Administrator : Setting Up the BWSE Plug-in for SmartMapper Application

Setting Up the BWSE Plug-in for SmartMapper Application

If you launch TIBCO Configuration Tool after you install the ActiveMatrix platform and TIBCO ActiveMatrix BusinessWorks Service Engine Plug-in for SmartMapper, by default, the TIBCO ActiveMatrix BusinessWorks Service Engine Plug-in for SmartMapper application is automatically installed on the DevNode.

However, if you use the newly created node, before deploying SmartMapper applications on this node, you must first complete the following steps to create the TIBCO ActiveMatrix BusinessWorks Service Engine Plug-in for SmartMapper application:

1.

Click the Application tab in the TIBCO ActiveMatrix Administrator.

2.

Click the button to add an application.

3.

Configure the application in the New Application dialog:

−

Enter a name in the Application Name field, for example, BWSE_SmartMapper_IT.

−

Select the An Existing Application Template radio button.

−

Click the Next button.

4.

Select the TIBCO ActiveMatrix BusinessWorks Service Engine Plug-in for SmartMapper Implementation Type DAA radio button in the application template list, as shown in Figure 3.

Figure 3 Select a Template for the Application

a.

Click the Next button.

b.

Review the setup information of the newly created application. Click the Save and Exit button.

c.

Select the newly created application from the applications list. Click the Distribution tab of that application.

d.

Select the application in the left-hand panel, then select the node on which you want to distribute it. The node named DevNode, shown in the Selected Nodes list, is the default nodes.

If you want to use another node, for example, the one named testNode, then move it from the Available Nodes list to the Selected Nodes list, and move the default DevNode from the Selected Nodes list to the Available Nodes list, as shown in Figure 4.

e.

Click the Save button.

Figure 4 Selecting Node

f.

Click the button to deploy the application.

You can select Deploy with Start, Deploy without Start, or More Deploy Options from the Deploy list.

If using the newly created node, you also need to deploy the TIBCO ActiveMatrix BusinessWorks Service Engine application on it.