Copyright © Cloud Software Group, Inc. All Rights Reserved
Copyright © Cloud Software Group, Inc. All Rights Reserved


Chapter 7 Phase 5: Deployment : Introduction

Introduction
When you have completed and tested the first prototype of your integration project in the development environment, you are ready to deploy it to a testing environment.
In a traditional business integration project, domain configuration is a labor-intensive process that is likely to require multiple iterations before all components are in place. The administrator must tweak the configuration files for different components on different machines. To optimize the configuration, administrator must manually keep a record of the different configurations that were tested.
TIBCO ActiveMatrix BusinessWorks, in contrast, allows you to use the TIBCO Administrator GUI to create a deployment configuration and then deploy the project.
TIBCO ActiveMatrix BusinessWorks Project Phases
When process design is complete and all testing from the TIBCO Designer GUI results in success, the project is ready for deployment.
The illustration below shows how a project moves through the development and deployment phases.
Figure 23 Project development phases
1.
2.
3.
4.
At this stage, the developer moves from the TIBCO Designer development GUI to the TIBCO Administrator run-time GUI and performs these tasks:
1.
2.
3.
4.
If appropriate, the project can be modified and saved from TIBCO Designer. In that case, you must create a new EAR file and place the new file into the deployment configuration. You must then stop and restart the desired deployment for the changes to take effect.
For more information about creating EAR files and deployment configurations, see TIBCO ActiveMatrix BusinessWorks Administration.

Copyright © Cloud Software Group, Inc. All Rights Reserved
Copyright © Cloud Software Group, Inc. All Rights Reserved