Configuring SAP System for bgRFC

The bgRFC transfer protocol provides a unified protocol between the SAP system and the adapter. It was originally introduced by the SAP system with the initial release of SAP ECC6.0. The bgRFC protocol has undergone several changes across SAP releases.

The adapter supports bgRFC protocol for an Outbound adapter and type T for transaction type only.

To configure an SAP system for bgRFC:

    Procedure

  1. Configure the RFC Destination. Log in to the SAP system. Run transaction SM59.

  2. Click Create in the Configuration of RFC Connections page.

  3. Click Yes in the Warning about selection of protocol window.

  4. Click Save.

    The transfer protocol for the RFC Destination requires basXML.

  5. Configure the interface of the RFC/BAPI.

  6. Run transaction SE37.

    Enter a function module in the Function Module field in the Function Builder: Initial Screen page.

  7. Click Display.

  8. Select the BasXML supported checkbox on the Function Builder page as shown in the the following figure

    Enter applicable values according to your requirements into the RFC Destination page as the following figure shows.