Configuring Dynamic Binding

There are four high-level steps for configuring dynamic binding. Perform the four procedures to configure an application to use dynamic binding.

1. Configuring Dynamic Binding.
   • Add target interfaces to a mediation component.
   • Specify that the interfaces are dynamic.
2. Set the dynamic reference task.
   • Add the Set Dynamic reference task to your mediation path.
3. Configure dynamic references in the composite.
   • Create a component reference and specify that it is wired by implementation.
   • Wire the dynamic component reference of the mediation component to the dynamic composite reference.
4. Create and deploy composites used by dynamic binding.
   • You can create composites with service virtualization that either implement the service or pass-through to a SOAP or JMS service.

Copyright © 2022. Cloud Software Group, Inc. All Rights Reserved.