Configuring an Environments Messaging Bus

You can configure an environment's messaging Bus from the GUI or by using the CLI.

The following configurations are possible:
  • SSL is disabled in the EMS server.
  • Both SSL and non-SSL connections are enabled in the EMS server.
  • Only SSL connections are enabled in the SMS server.

GUI

Prerequisites

Make sure you stop all applications in the environment before configuring the Messaging Bus properties.

Note: Restart the node after configuring the Messaging Bus properties.

Procedure

  1. Click Infrastructure > Environments.
  2. Click an environment.
  3. Click the Configuration tab.
  4. Click the Messaging Bus link.
  5. Configure properties according to Messaging Bus Reference.
  6. Click Save.

CLI

Procedure

  1. In the data file, specify a MessagingBus element in full format.
  2. In the AMXAdminTask element, set the action attribute to add and the objectSelector attribute to Environment/MessagingBus.
  3. Invoke the command-line interface on the build file.