Viewing Resource Attributes from the Resource List

You can view resource attribute information, from the resource list, for a single resource in the container.

Procedure

  1. In the resource list, select the desired resource.
  2. Locate the Resource Attributes section in the details pane below the resource list, (note that the details pane is not populated when multiple resources are selected). For example:

    Any values stored in the resource attributes for the selected resource are shown in the Attribute Value column.

    The icon to the right of each row tells you the source of the value in each attribute, as follows:

    Icon Meaning
    		The value has been added through the Organization Browser (Resource Editor).
    		A “grayed out” version of the icon shown for values added through the Organization Browser (see above) means that there is “no value”.
    		The value has been added to the attribute via mapping to an LDAP attribute.

    Note that you cannot edit resource attributes in the Resource Editor if the resource attribute is mapped to an LDAP attribute.

    For information about mapping resource attributes to LDAP attributes, see Mapping Resource Attributes.