Installation Fails to Complete Due to Pending Tasks on BPMNode

Installation can fail to complete due to pending tasks on the BPMNode. In this situation, some messages are displayed and the installation does not complete.

The messages are similar to the one shown below. 

INFO - 41 tasks are pending on node [BPMNode] on host [SystemHost]

This message indicates that the tasks could not be completed due to a variety of reasons.

  • Check the status of the BPMNode in the Administrator console. An error message on the console could indicate the cause of this error.
  • You can also look at the BPMNode logs for additional information.
  • Check the "Installation Requirements" and "Pre-install Considerations" sections in the TIBCO ActiveMatrix BPM Installation and Configuration Guide for any outstanding requirements or pre-installation tasks.

(This applies to Linux only)

Procedure

  • If the error indicates that you ran out of file descriptors, set the file descriptors to 10,000 for the user who is performing the installation.
Next topic: Installation Failure Due to Missing Database Objects
Previous topic: Installation Error Caused by Special Characters in the Hostname