Deploying from TIBCO Business Studio

If you cannot connect to the server, you will see an error message like this:

You could try the following steps to investigate the cause of your failure to connect:

• Make sure that the server to which you are trying to connect is switched on.
• Check that the parameters of the deployment server, particularly the IP address and port to which it is trying to connect, are correct.

TIBCO Business Studio DAA Validation Issues

TIBCO Business Studio runs a series of checks on generated DAA files. The DAA could be considered valid by TIBCO Business Studio, but not all requirements can be catered for. For example, a BPM project could be dependent on an Organization model. If that Organization Model is not deployed, the deployment of the BPM project will fail even though the DAA is considered valid.

Another example of this is project where the bindings need to be configured in the runtime environment. A "Deploy with Start" on such a project may fail, but it may be possible to successfully deploy the project, configure the bindings, and then start the application.

TIBCO Business Studio Deployment Server Refresh Issues

Occasionally, a manual refresh of the deployment server in TIBCO Business Studio is required to synchronize with Administrator server. Typically, this is necessary after resource instances and or non-BPM applications (for example, Mediation) with virtual bindings are deployed from outside of TIBCO Business Studio. When deploying a BPM application with a dependency on the aforementioned components (that were deployed outside of TIBCO Business Studio), the binding/wiring dialog does not list those components.