Refreshing the Process Template List

The Process Template list that is initially displayed is a snap shot of the process templates available at that point in time. You can refresh the list to get the most recent list of process templates from BPM.

You can set up the template to refresh automatically, or you can specify the auto refresh interval.

Procedure

  • Click The icon is two concentric arrows pointing in opposite directions.from the Process Views gadget and Openspace automatically refreshes,
  • Configure the Process Views gadget to automatically refresh the list at specified intervals.
    Note: By default this is set to 0 which means auto-refresh is turned off.
    1. From the Process Views gadget, click The icon is two green concentric arrows pointing in opposite directions with a circle in the bottom right hand corner.
      The Configure auto refresh dialog is displayed.
    2. In the Auto refresh interval (seconds) box, type the number of seconds you would like between refreshes (the minimum you can specify is 30 seconds), then click OK.
    3. Enter 0 to turn off auto-refresh.