Searching in Current Report

Basic Search

To search for values in the current diagnostic report or table, enter the text in the search field and click . The filtered results are displayed in the current table.

To clear the search results, click .

Advanced Search

1. Click at the bottom of the table. The Advanced Search dialog is displayed. By default, the Advanced Search dialog shows all the fields that are displayed in the current table. As an example, if you are on the Host tab, the Advanced Search dialog contains the following fields.

   

2. Using the dropdown at the top-left corner, specify whether all or any of the conditions must match:

   All - Shows results which match ALL the specified conditions.

   Any - Shows results which match ANY ONE of the specified conditions.

3. Specify a sub-condition by clicking , if required.
4. To add a condition to the existing list, click + at the top of the dialog.
5. To remove an existing condition from the list, click – beside the condition.
6. Click Find to search for the text.

The filtered results are displayed in the table.

To remove the Advanced Search filter and refresh the table content, click .