Copyright © Cloud Software Group, Inc. All Rights Reserved

MAPPING

The MAPPING tab of the Config UI provides the configuration parameters for the following areas:

Mapping

Using the Mapping tab, you can register the transformation (XSLT) files with the Core Engine.

To add a new mapping, follow these steps:

1.	Click the Mapping tab.

2.	Click the Add property icon to create a new mapping.

3.	Enter the following mapping configuration parameters:

Table 43 Mapping Configuration Parameters

Parameter	Description
Mapping Configuration
Type	Select the type of mapping from the drop-down list. The possible values are: • RV • XSLT
RV Type
Subject	Specifies the RV subject to send the mapping request to.
Transformation Name	Specifies the name of the transformation to perform on the message.
XSLT Type
New File	The location of the transformation file.
Existing Files	The existing transformation file.
Response Type	Specifies the response type. Select one of the possible values as follows: − Payload − Full See Transformations (XSLT Mapping)

Schemas

Using the Schemas tab, you can configure the list of XSD files. The XSD files are used to validate the northbound request and response documents.

To add a new schema, follow these steps:

1.	Click the Schemas tab.

2.	Click the Add property icon to create a new schema.

3.	Enter the details for schema files, as follows:

Table 44 Schemas Configuration Parameters

Parameter	Description
Schema Key	Specifies the unique ID of the XSD schema file.
New XSD File	Specifies the location of the XSD file.
Existing XSD File	Specifies the existing XSD file.

Error Maps

Using the ErrorMaps tab, you can define all the error messages supported by TIBCO API Exchange Gateway.

To add a new errormap, follow these steps:

1.	Click the ErrorMaps tab.

2.	Click the Add property icon to create a new error map.

3.	Enter the details for Error Maps configuration, as follows:

Table 45 ErrorMaps Configuration Parameters

Parameter	Description
Error Id	The External ID of the ErrorMap. Must be globally unique.
Status	Specifies the status of the transaction reported by the gateway error message.
Component	Specifies the component of the gateway for this error message.
Error Description	Specifies the description of the error.
Category	Specifies the category of the error. The allowed values are: − ServiceException(SVC:) − PolicyException(POL:)
Fault Code	Specifies the SOAP fault code. Usually, the value is Client.
Fault String	Specifies the SOAP fault string. For example, SVC0002
Fault Actor	Specifies the SOAP Fault Actor.
Message Id	Specifies the message ID or any client specific code. For example, SVC0001
Text	Specifies the error text with locations for variables to be embedded indicated by “%1”, “%2”, and so on.
Variables	A list of strings separated by “,” that the gateway client uses for token replacement in the text.

Copyright © Cloud Software Group, Inc. All Rights Reserved