Copyright © Cloud Software Group, Inc. All Rights Reserved

SSL Support for JMS Transport

TIBCO API Exchange Gateway supports SSL for SOAP JMS transport and ESB channels at the facade and target sides. The SSL configuration parameters for JMS transport are configured using the Show SSL Properties tab on the Config UI.

Go to the Show SSL Properties tab as follows:

•	On the home page of the Config UI, select the Gateway Engine Properties in the drop-down list.

•	Click the Transport link.

•	Expand the required JMS transport node. For example, to set the SSL properties for ESB channel at the facade side, expand the JMS Facade ESB Connection node.

•	Click the Show SSL Properties tab.

See Show SSLProperties to configure the SSL connection parameters for JMS transport.

SSL is supported only when using TIBCO Enterprise Message Service.

Copyright © Cloud Software Group, Inc. All Rights Reserved