Configuring Payload Size Throttles

The payload size throttles are configured using the Config UI. You can configure the throttles for the payload size of request, response, or both request and response messages.

To configure the payload size throttles, follow these steps:

Procedure

  1. Start the GUI server, if not already running.
  2. Log in to the Config UI using your credentials.
  3. Add a new configuration or select an existing configuration.
  4. Click the MONITORING tab on the right hand side.
  5. Click the Monitors tab.
  6. Specify the following parameters:
    Payload Size Throttle
    Parameter Description
    Monitor Name
    • Specifies the name of the throttle. For example, T2
    • Required.
    Monitor Type
    • Specifies the type of throttle. Select one of the possible values from the drop-down list for the payload size throttle: 
      • Rate 
Quota
    • Required.
    • Example, Rate
    Interval Specifies a time period for which the maximum count of throttles are allowed.
    Max Limit Specifies the maximum number of throttle count allowed during the throttle interval period.
    Monitor Counter Specifies the message type for which the payload size is calculated. Select one of the possible values from the drop-down list: 
    • Input Payload Size
Output Payload Size
Transaction Payload Size
Contents
Search Results