Configuration for Reset Mode of HealthCheck

When you enable the Reset mode of HealthCheck for each target operation in a target operation group of RoundRobinWithFailover or WeightedRoundRobinWithFailover, configure the ResetInterval parameter.

To configure the ResetInterval parameter for a target operation, follow these steps:

Procedure

  1. Start the GUI server, if it is not already running.
  2. Log in to the Config UI using your credentials.
  3. Add a new project or select an existing project under Projects, as applicable.
  4. Click the Target Operation Groups tab.
  5. Select a target operation group and expand the node.
  6. Select a Target Operation of RoundRobinWithFailover or WeightedRoundRobinWithFailover type for the Type parameter from the drop-down list.
  7. Expand the Health Check node.
  8. Select Reset for the Health Check Mode parameter from the drop-down list.
  9. Type the value of the Reset Interval parameter. See Reset Interval.