Configuring a Target Operation Group

To configure a target operation group, follow these steps:

Procedure

  1. Ensure that you are on the Routing tab of the Config UI. See Clicking the ROUTING Tab.
  2. Click the Target Operation Groups tab on the top menu.
  3. Enter the value for the following fields:

Target Operation Group Configuration
Parameter Description
Group Name
  • Specifies the name of the target operation group. This can be any name defined by a user.
  • This is a Required field.
Description A short user description of the target operation group.
Type Specifies the type of target operation group. See Routing Algorithms for Target Operation Group for details.

Select one of the possible values from the drop-down list:

Target Operations Specifies the list of target operations in the group. Add multiple target operations using the Add Target Operation( ) icon to a target operations group. The target operations must be configured under the Target Operations tab.

  1. Save the changes to the configuration.
    Note: If you configure a target operation group of the type RoundRobinWithFailover or WeightedRoundRobinWithFailover, you must define the HealthCheck configuration for each target operation in the group. See HealthCheck Configuration for Target Operation for configuration details.