Configuration Setup

This section explains the configuration setup required for Rendezvous communication.

To ensure that Rendezvous is only used as an internal transport with the Core Engine, perform the following actions:

  • Kill any running Rendezvous daemons on the system.
  • Explicitly start the Rendezvous daemons.

    You can start the Rendezvous daemons using the Rendezvous session parameters as defined in the ASG_CONFIG_HOME/asg.properties file. By default, the Rendezvous connection parameters are defined as follows:

    • RvDaemon tcp:7500
    • RvNetwork
    • RvService 7500

      If you want to change the network, daemon or service parameters for the Rendezvous transport connection, edit the properties defined in the ASG_CONFIG_HOME/asg.properties and ASG_CONFIG_HOME/asg_cl.properties files. See Setting Rendezvous Transport Properties.

Note: If the Gateway components are deployed on the machines within the same subnet, the rvd daemon is used. In case the components are deployed on the machines within different subnets, it requires the rvrd daemon setup. See TIBCO Rendezvous Administration Guide for the configuration setup and starting the Rendezvous daemons.