Policy
|
Specifies a name for the policy. The policy name must be configured under the
Policy Mapping tab.
|
URI
|
Specifies the URI of the operation to which the policy is applied.
Note: If the URI in facade operation is left blank, then URI field for security binding should use SOAP action instead of URI.
|
Facade Operation
|
Specifies the operation to which the policy is applied. The facade operation must be configured in the
Facade Operation
tab.
|
Target Operation
|
Specifies the target operation. The target operation must be configured in the
Target Operation tab.
|
Binding
|
Specifies the binding component that the policy is applied to. This could be either a facade operation (service) or a target operation (reference).
|
Flow
|
Specifies the flow of the request or response. The possible values are:
|
Partner
|
Specifies the partner to which the policy is applied. This field can be left blank in case no partner needs to be applied.
|
Type
|
Specifies the type of the request.
Note: Set this to SOAP for any SOAP request, or to http for any non-SOAP http request.
|