Policy Binding

Using the Policy Binding tab on the Config UI, you can associate a registered policy with one or more target operation endpoints.

To map a policy to a target operation, follow these steps:

Procedure

  1. Click the Policy Binding tab.
  2. Click the Add property icon to map a policy file.
  3. Enter the details for policy mapping configuration, as follows:
    Policy Mapping Configuration Parameters
    Parameter Description
    Policy Specifies a name for the policy. The policy name must be configured under the Policy Mapping tab.
    URI Specifies the URI of the operation to which the policy is applied.
    Note:
    • If the URI in facade operation is left blank, then URI field for security binding should use SOAP action instead of URI.
    • For XML/JMS or SOAP/JMS, the SOAP action can be used instead of the URI.
    Facade Operation Specifies the operation to which the policy is applied. The facade operation must be configured in the Facade Operation tab.
    Target Operation Specifies the target operation. The target operation must be configured in the Target Operation tab.
    Binding Specifies the binding component that the policy is applied to. This could be either a facade operation (service) or a target operation (reference).
    Flow Specifies the flow of the request or response. The possible values are:
    • in
    • out
    Partner Specifies the partner to which the policy is applied. This field can be left blank in case no partner needs to be applied.
    Type Specifies the type of the request.
    Note: Set this to SOAP for any SOAP request, or to http for any non-SOAP http request.