Rendezvous Mapping Type

Configuring Rendezvous Mapping Type.

Procedure
1. Start the GUI, if not already started. See Starting GUI for details.
2. Click the MAPPING > Mapping tab for a project.
3. Type the parameters, as follows:

   RV Mapping Type Configuration

   Parameter	Description
   Mapping Name	The name of mapping
   Type	RV (select from the drop-down list.)
   Subject	Specifies the RV subject to send the mapping request to
   Transformation Name	The transformation to perform on the message. If it is default, the transformation is determined by mpSubject. Other values force specific transformation.