Starting the Installer

Procedure

  1. Extract the contents of the installation archive to a temporary directory.
  2. You can start the installer by entering the following command:
    install_package_name.bin -is:tempdir /new_tmp

    where /new_temp has sufficient free disk space.

Result

The installer calculates the disk space required in the product home location for the selected components. The calculation is done before the actual installation (copying of files to the system) begins. The installer proceeds only if sufficient free disk space is available in the product home location.

However, if disk space is consumed by another process while the installer is copying the files, and if the required disk space is thereby reduced, the installer might fail, and then gives a failure message.

While performing installation, avoid running other processes that consume disk space in the product home location.

On Linux platforms, this product can consume 600 MB of free space under TIBCO_HOME.