Copyright © TIBCO Software Inc. All Rights Reserved

Configuring Services Plug-in for a Partner

To configure a partner in a business agreement:

1.	Click BusinessConnect > Participants.

2.	Click New.

3.	On the New Participant page, type a partner’s name in the Name field.

4.	Select Partner in the Type list.

5.

Click OK.

Both the Buyer (Host) and Seller (Partner) now are displayed on the Participants panel.

6.	Click the partner link.

7.	On the Edit Host Participant page, select the Active check box.

8.	Click Apply.

Enabling Protocol for Initiator Partner

1.	On the Edit Partner Participant page, click the Protocols tab.

2.	Click Enable.

The Enable page with installed protocols is displayed.

3.	Select the EZComm check box.

4.

Click OK.

The EZComm protocol is now in the Protocol Name list.

5.	Click the EZComm link.

The Edit Enabled Protocol: EZComm page is displayed with the following tabs:

−	General Tab

−	Transports Tab

General Tab

 

Select or enter information as explained in Table 16.

Table 16 Partner Settings: General Tab

Field	Description
AS2 Identifier	An identifier to use in the AS2-To header field of the HTTP message. This identifier should be mutually agreed upon between trading partners. For more information about AS2 Identifiers, see TIBCO BusinessConnect Trading Partner Administration Guide, Disabling Session Cache for HTTPS.
Valid Email Address List	Enter the list of valid email addresses for this participant, separated by a semicolon or comma. For details, see TIBCO BusinessConnect Trading Partner Administration Guide, Table 28, Configuring HTTP/S for a Trading Partner: General Tab.
Allow override of filename via HTTP parameter	If this check box is selected, and a file reference is being passed from the private process, then the name of the file is passed on to the Responder in an HTTP header called filename. This property also applies for the Inbound transports, specifically, when AS2 headers have the filename embedded that are sent to the private process. For more information, see Allow override of filename via HTTP parameter (applies only to HTTP/S transports).
Duplicate Detection for Outbound	If selected, all incoming private process messages and the outgoing responses are checked for duplicate detection. If a request is found to be a duplicate, the transaction is terminated and an error advisory is sent.
Duplicate Detection for Inbound	All incoming requests for Responder and Initiator are checked for duplicates. If any duplicates are found, the duplicate field in the private process message is set to true.

Click Save.

Transports Tab

To add a transport for the partner:

1.	Click the Transports tab.

2.	Click Add.

Enter data for the new transport as explained in Table 17.

Table 17 New Transport for the Partner

Field	Description
Name	Enter the name for the transport (required).
Type	Select the transport type from the Type list. To configure a specific transport for the partner, see TIBCO BusinessConnect Trading Partner Administration Guide, and then refer to the appropriate chapter for the transport .

3.

Click OK.

Define URL

To define the URL for the partner, enter the following information:

URL (required): www.hostname:6700/dmz/EZComm.

Copyright © TIBCO Software Inc. All Rights Reserved