Setting Relationship between Customer and Account

Procedure

Select the icon from the Palette; click on the outer edge of the Customer repository and drag to the outer end of the Account repository to define a relationship.

Tip: When attempting to draw a relationship from a source repository, ensure that you see an arrow as indicated below.

Once you correctly touch the edge of a repository, you will see the arrow icon. When dragging to define the relationship, the cursor changes to a hand icon; release the cursor only when you touch the outer edge of the target repository and once you see the cursor change to an arrow again.
Provide a forward and reverse relationship name. By default, the focus is on the forward relationship (indicated by a forward arrow icon).
1. Enter CustomerToAccount as forward relationship name.
2. Click on the reverse arrow icon and provide AccountToCustomer as the reverse relationship name.
Note: The multiplicity icons on the relationships (*) do not influence the model since MDM does not support it, they are simply indicative of multiplicity on the main model diagram.