Fault Tolerance

Fault Tolerance allows multiple application nodes to substitute for each other. When the primary application node terminates unexpectedly, the role held by the primary application node can be taken over by an application node in the standby state. In the process of replacement, the standby application node is promoted to the primary application node.

To apply Fault Tolerance, you can select one of the following methods:

  • In the process designer, right-click and select Show Properties View. Navigate to the Advanced tab. Select Activation as Single AppNode.
  • Setup TIBCO ActiveMatrix BusinessWorks™ Administrator in a Fault Tolerance group.

For more information on fault tolerance in ActiveMatrix BusinessWorks, refer to the TIBCO ActiveMatrix BusinessWorks™ Administration guide.