Installation Overview

You can install TIBCO ActiveMatrix BusinessWorks™ Plug-in for Change Data Capture either by using the TIBCO Universal Installer or an update site.

Installing by Using the TIBCO Universal Installer
You can install the plug-in by using the TIBCO Universal Installer, in the following modes: GUI, console, and silent. To skip to the procedure, see Installation Modes and Procedures
Installing by Using an Update Site
You can install the plug-in from within TIBCO Business Studio™ for BusinessWorks™ by using the public update site maintained by TIBCO, using a local update site managed by your organization, or BusinessWorks Plug-ins Manager.

The plug-in must be installed into an existing installation environment where TIBCO ActiveMatrix BusinessWorks™ is already installed. The installation environment of ActiveMatrix BusinessWorks™ is referenced as TIBCO_HOME.

Note: TIBCO recommends that you use the same mode for uninstallation that you used for installing the plug-in. Using different methods for installation and uninstallation might cause some problems during uninstallation.

Subtopics

Did you find this helpful?

Yes No