Fault Tolerance

Fault Tolerance allows multiple application nodes to substitute for each other. When the primary application node terminates unexpectedly, the token held by the primary application node can be taken over by an application node in the standby state. In the process of replacement, the standby application node is promoted to the primary application node.

To apply Fault Tolerance, select the following:

  • In the process designer, right-click and select Show Properties View. Navigate to the Advanced tab. Select Activation as Single AppNode.
  • Setup ActiveMatrix BusinessWorks Administrator in a Fault Tolerance group.
For more information on fault tolerance in BusinessWorks, refer to the TIBCO ActiveMatrix BusinessWorks™ Administration guide.
Note: In case of file serializer activity Fault Tolerance is supported for only Wip Creation Mode as one job per file.