CombinationChartBarProperties.Width Property

CombinationChartBarProperties Width Property

TIBCO Spotfire 6.5 API Reference

Gets or sets the relative width of the bars. Allowed values are in the range [0, 100].

Namespace: Spotfire.Dxp.Application.Visuals
Assembly: Spotfire.Dxp.Application (in Spotfire.Dxp.Application.dll) Version: 14.10.7525.5058 (14.10.7525.5058)

Syntax

C++

Copy to Clipboard Print

public float Width { get; set; }

public float Width { get; set; }

Property Value

Type: Single
The width of the bars as a percentage. Defaults to 80.

Remarks

This property is only used when the x axis is categorical. A value of 100 means the bar will occupy the full width of a category. A value of 0 will cause the bars will have a minimum width.

If the x axis is continuous, this property is ignored. If binning is used on the x axis, the bars will occupy the full width of the bins. If binning is not used, bars will have a minimum width.

Version Information

Supported in: 6.5, 6.0, 5.5, 5.0, 4.5