Launching automated data profiling

To perform automated data profiling:

1. Navigate to the table containing the data you want to profile.

2. From the table's Actions menu, select Insight (New) > Launch data profiling.

   Note

   If you do not see this service in the menu, check with an administrator to ensure you have sufficient permission to run the service.

   

   Automatic profiling results are shown below. The first results that display correspond to the Addresses table. The section underneath shows the table's fields. Drill down to see more results for each field by clicking on an indicator in the area outside of the chart.

   Note

   The following data types are not supported and not included in profiling results: FK, associations, multi-value FKs, selected nodes and multi-value groups.