Server Properties

The fields on the Server Properties page correspond to the parameters in the tibemsd.conf configuration file. The fields have been organized to mirror the parameter categorization given in the TIBCO Enterprise Message Service User’s Guide, as shown here:

Heading See Parameter Category
Global Parameters Global System Parameters
Network Failure Detection Detecting Network Connection Failure Parameters
Connection and Memory Connection and Memory Parameters
Message Tracking Message Tracking Parameters
DB Driver Extensible Security Parameters
JVM Parameters JVM Parameters
Advanced Properties None. This interface should be used only with direction from TIBCO Support.

FT Active

The FT Active radio button determines the ft_active parameter setting for the secondary server. The ft_active setting for the primary server is determined by the Secondary Listens URL settings in the main Fault Tolerance page.

EMSCA Deployment Listens

The URLs entered here are used by the Central Administration server to communicate with the EMS server. If fault tolerance is configured, you must add two EMSCA Deployment Listens.