Connecting the Appliance to Your Network

The TIBCO Enterprise Message Service Appliance is configured to support dual uplink ports to the network.

1. Insert transceiver adaptors into ports 37 and 41 (or one of them). Connect to your network using the 10Gb/s SFP+ transceiver and the 40Gb/s to 10Gb/s QSFP to SFP+ adaptor.
   Note: If the chassis type is F64, insert transceivers in ports 41 and 42 (or one of them).

   Note: If the chassis type is F64, remember to use uplink ports 41 and 42 in place of 37 and 41 for the remainder of this document.

   Note: If the chassis type is F64, Pluribus Certified 1Gb/s transceivers are deprecated, but still supported.
2. Connect the transceivers to your network using the appropriate cables.