Using the CLI to Make Configuration Changes
The CLI offers a way to make some changes to the TIBCO Enterprise Message Service Appliance configuration.
To prevent inadvertent changes, commands that modify the appliance configuration are not available through the main CLI. To access these commands, you must enter the TIBCO EMS Appliance Setup menu, and explicitly save and apply changes made while in that interface.
Procedure
- From the CLI, issue the setup-enable command to enter the TIBCO EMS Appliance Setup Interface.
- Make the desired configuration changes using the available commands. See Configuration Setup Commands for more information.
- Issue the config-save command to save the changes made.
- Issue the config-apply command to apply the changes.
- Use the exit or quit command to exit the TIBCO EMS Appliance Setup Interface and return to the main CLI.
Copyright © Cloud Software Group, Inc. All rights reserved.