remove-snapshots

This command removes Disaster Recovery (DR) snapshots from TIBCO Enterprise Message Service™ appliance. 

remove-snapshots [-all]
-all By default, the latest snapshot is not removed.

If you use the option -all, the latest snapshot is also removed.

This command should only be run when DR services are disabled.

If used inappropriately, this command can prevent a successful recovery of the data. For example, if you remove snapshots from the production site without removing them from the backup site you could have problems with data recovery.

Note: If you use the -all option to remove snapshots from a member of a DR cluster, then you should run remove-snapshots -all on both DR Backup appliances to ensure correct snapshot numbering going forward.