Uplink Configuration

Ports 41 and 42 are configured in an active-passive-mode Link Aggregation Control Protocol (LACP) trunk. These ports should uplink to network switch ports that are also trunked, and configured for active-passive LACP with port mode fast.

Ports 41 and 42 can be uplinked to two separate network switches as long as these switches support LACP ports across multiple switches. By default, only port 41 is enabled at startup. If you need a different uplink configuration, this can be configured after the software installation is complete using the uplink-config command. Consult your switch manufacturer's documentation to configure this option on the network switch.