Configuring Tests

To open the configuration of the test, click on the arrow symbol to display the details. The expanded details area shows two tables: one for the injected SOD and one for the expected SOD. Start by configuring injected ServiceOrderData:

  • Set SOD attributes: originator, domain, verb, priority, customerid, and dataset.

  • Click add a ProductOrderData and set the POD attributes (repeat for each POD in the service order).

Next, configure expected ServiceOrderData:

  • Specify which of the two terminal processes is the expected destination (good : positive test, cancel : negative test).

  • Specify the expected SOD attributes: originator, domain, verb, priority, customerid, status, dataset, ...

  • Click add a ProductOrderData and specify the expected POD attributes : productVerb, productName, isEnabled, isTechnical, processName, slice (repeat for each POD in the service order).

  • Click add a WorkOrderData and specify the expected WOD attributes: cartInstName, elementType, commandName, dataset, ... (repeat for each WOD in each product order).

Once the test is configured, click Save, or Save as to use a different filename.