Editing an EAI Web Service Step

To edit an EAI Web Service step, do the following:

1.

Double-click the Web Service step in your procedure.

2.

The EAI Step Definition dialog is displayed.

3.

Click EAI Call-Out Definition.The Web Service Integrator wizard is displayed.

Note

• If you are editing a step that has a web service defined for a Withdraw action, you can select the Edit only the Withdraw action checkbox to skip the dialogs related to the main web service and proceed directly to the dialogs for the Withdraw action web service. Do not deselect the Define Withdraw action checkbox unless you want to delete the web service that has been specified for the Withdraw action (see Deleting a Withdraw Action). • If you are editing an EAI Web Service step created with a previous version of the TIBCO iProcess Web Services Plug-in, it will not contain security information, to apply SOAP security features, you must re-edit the step and select a security profile.

4.

Continue through the wizard and modify any settings as required.

Note

If when the step was created, the WSDL was obtained from a UDDI repository, when you edit the step, the WSDL that was obtained is presented as a static WSDL. You can re-retrieve the WSDL by selecting UDDI and searching again. If the WSDL in the repository has changed since the step was created, the displayed WSDL is updated.

5.

Click Finish to save your new settings.