An Under Construction Symbol Appears on a Step

Copyright © Cloud Software Group, Inc. All rights reserved.

Appendix A Troubleshooting Procedure Definitions : An Under Construction Symbol Appears on a Step

An Under Construction Symbol Appears on a Step

Problem

One or more steps in your procedure definition show an Under Construction sign over the step icon.

Description

When defining procedures, you need to be aware that steps need to have a certain amount of basic information. If this information is not defined, iProcess warns you by placing an Under Construction sign on the step.

Solution

The following list describes the possible solutions you can try for each step type where you see a red question mark.

•

For a normal step, select the step and right-click to select Addressees. Make sure an addressee has been entered for this step.

•

For a Sub-procedure call step, select the step and right-click to select Sub-Procedure. Make sure a sub-procedure is chosen in the Sub-Procedure Name field.

•

For a Dynamic Sub-procedure call step, select the step and right-click to select Dynamic Sub-Procedure. Make sure the Sub-Procedure Name Array field contains an array field and that all the required input fields are mapped.

•

For an EAI step, select the step and right-click Description. Make sure a valid script definition has been entered and check that an EAI type has been selected.

•

For a Wait step, make sure it is connected to 2 or more steps.

•

For a Condition step, select the step and right-click Condition. Enter a valid condition.