Copyright © Cloud Software Group, Inc. All Rights Reserved
Copyright © Cloud Software Group, Inc. All Rights Reserved


Chapter 6 Administering Process Attributes : TIBCO Rendezvous Configuration : RV_NETWORK

RV_NETWORK
TIBCO Rendezvous Configuration
Summary
This attribute is used to configure the iProcess Server Manager with the network used for outbound session communications in TIBCO Rendezvous.
Applies To
This attribute must be set for ALL processes.
Permissible Values
If you are using the iProcess Server Manager, the setting of this process attribute must correspond to the network configuration parameter in TIBCO Rendezvous.
If your TIBCO Rendezvous installation does not use the default configuration, you must ensure that the setting of this attribute matches the setting of the network configuration parameter in TIBCO Rendezvous. For more information about the network configuration parameter, see TIBCO Hawk Installation and Configuration.
Default Value
This attribute is not defined on a newly installed iProcess Engine node. In this case, the default value is:
The attribute only appears in the output of the SHOW_ALL_ATTRIBUTES command if you have explicitly assigned a value to it using the SET_ATTRIBUTE command. The default setting is not displayed
See Also
RV_DAEMON, RV_SERVICE and Configuring the iProcess Server Manager

Copyright © Cloud Software Group, Inc. All Rights Reserved
Copyright © Cloud Software Group, Inc. All Rights Reserved