Copyright © Cloud Software Group, Inc. All Rights Reserved

RV_SERVICE

TIBCO Rendezvous Configuration

Summary

This attribute is used to configure the iProcess Server Manager with the User Datagram Protocol (UDP) service group used for session communications in TIBCO Rendezvous.

Applies To

This attribute must be set for ALL processes.

Permissible Values

If you are using the iProcess Server Manager, the setting of this process attribute must correspond to the service configuration parameter in TIBCO Rendezvous.

By default, TIBCO Rendezvous uses the service port number 7474. You do not need to change this attribute if your configuration uses this default port number.

If your TIBCO Rendezvous configuration does not use the default port number you must specify the service being used, either by its name or its port number. For more information about the service configuration parameter, see TIBCO Hawk Installation and Configuration.

Default Value

This attribute is not defined on a newly installed iProcess Engine node. In this case, the default value is:

Machine ID	Process	Instance	Value
0	ALL	0	7474

The attribute only appears in the output of the SHOW_ALL_ATTRIBUTES command if you have explicitly assigned a value to it using the SET_ATTRIBUTE command. The default setting is not displayed

See Also

RV_DAEMON, RV_NETWORK and Configuring the iProcess Server Manager

Copyright © Cloud Software Group, Inc. All Rights Reserved