Copyright © Cloud Software Group, Inc. All Rights Reserved

AUTO_PURGE_DELAY

Procedure Configuration

Summary

This attribute defines the number of days to delay the auto-purge operation.

This attribute is used when the Purge On field in the Deadline tab of the Properties dialog is set as a date field, and the value of the date field is not given.

Applies To

This attribute must be set for the BG processes.

Permissible Values

The attribute value must be a numeric value greater than or equal to 0.

Default Value

This attribute is not defined on a newly installed iProcess Engine node. In this case, the default value is:

Machine ID	Process	Instance	Value
0	ALL	0	90

The attribute only appears in the output of the SHOW_ALL_ATTRIBUTES command if you have explicitly assigned a value to it using the SET_ATTRIBUTE command. The default setting is not displayed.

Notes

For more information about setting auto-purge delay, see “Setting Auto-Purge and Deadlines” in TIBCO iProcess Modeler Procedure Management.

Copyright © Cloud Software Group, Inc. All Rights Reserved