Port Range swadm Commands
The following table summarizes all the swadm commands that you can use to administer port ranges. Each command is fully described in the following sections.
|
To do this... |
Use this command... |
|
Define a new port range. |
|
|
Delete an existing port range. |
|
|
Modify an existing port range (for example, to change the number range or operating mode). |
|
|
Place an iProcess Engine server behind a defined port range, or remove an iProcess Engine server from behind a defined port range. |
|
|
Show how the ports for a particular port range are currently allocated. |
|
|
Show the details of all defined port ranges and the iProcess Engine servers that are sitting behind them. |