AUTO_PURGE_DELAY
Summary
This attribute defines the number of days to delay the auto-purge operation.
Note: This attribute is used when the Purge On field in the Deadline tab of the Properties dialog box is set as a date field, and the value of the date field is not given.
Applies To
This attribute must be set for the BG processes.
Permissible Values
The attribute value must be a numeric value greater than or equal to 0.
Default Value
This attribute is not defined on a newly installed iProcess Engine node. In this case, the default value is:
|
Machine ID |
Process |
Instance |
Value |
|
0 |
ALL |
0 |
90 |
The attribute only appears in the output of the SHOW_ALL_ATTRIBUTES command if you have explicitly assigned a value to it using the SET_ATTRIBUTE command. The default setting is not displayed.
Notes
For more information about setting auto-purge delay, see “Setting Auto-Purge and Deadlines” in TIBCO iProcess Modeler Procedure Management.