DEF_MAJOR_VERS

Procedure Configuration

Summary

This attribute defines the default major version number that TIBCO iProcess Modeler will use when a new procedure is saved.

Applies To

This attribute must be set for ALL processes.

Permissible Values

The attribute value must be a numeric value greater than or equal to 0.

Default Value

This attribute is not defined on a newly installed iProcess Engine node. In this case, the default value is:

Machine ID	Process	Instance	Value
0	ALL	0	0

The attribute only appears in the output of the SHOW_ALL_ATTRIBUTES command if you have explicitly assigned a value to it using the SET_ATTRIBUTE command. The default setting is not displayed.

Notes

For more information about the use of version numbering with procedures, see “Using Version Control” in TIBCO iProcess Modeler Procedure Management.

See Also

DEF_MINOR_VERS, PROC_VER_COMMENT, PROC_VER_INC