USERPROCS

 

This parameter is currently not used by the iProcess Engine.

Section

STAFFPRO

Initial Value

1

Units

N/A

Range

1 to SYSPROCS

Description

This parameter is similar to SYSPROCS except that is imposes the same limit on a per user basis. This is mainly to avoid a single user being able to use all the available Process Invocation slots.

Tuning

Tuning of this parameter is a fine tune on the SYSPROCS value. If your application uses Process Invocations a lot then being able to distribute the SYSPROC allocation evenly across all the users will give generally better response.

There is obviously no point in setting USERPROCS greater than SYSPROCS. But if all Process Invocations are executed as the same user then the value of USERPROCS must obviously be set to SYSPROCS to get maximum benefit.