WQS_GATHER_RPC_STATS

Summary

This attribute allows the gathering of RPC call stats within the WQS process to be configurable.

This attribute should be set for the WQS process.

The attribute value must be one of the following:

Value	Meaning
0	RPC stats gathering is turned off.
1	RPC stats gathering is turned on.

The attribute is assigned the following default value when iProcess Engine is installed.

Machine ID	Process	Instance	Value
0	WQS	0	0

When the attribute is turned off and then on again, any previously gathered stats are not retained.

To use the attribute, turn on R=2 debug on the WQS process, set the process attribute and the stats will be seen in the debug log.

TIBCO recommends that this attribute be turned off unless you specifically require these stats.