WQS_SESSION_TIMEOUT
WIS and WQS Process Configuration
Summary
This attribute defines the timeout period (in seconds) after which a WQS process will automatically shut down, starting from the time at which it was last accessed (by a TIBCO iProcess Workspace, SAL application or iProcess Objects Server).
Applies To
The attribute can be set for a WQS process.
Permissible Values
The attribute value must be one of the following:
|
Value |
Meaning |
|
0 |
Do not timeout WQS processes. |
| n |
The timeout period, where n is any integer value equal to or greater than 60. |
Default Value
This attribute is not defined on a newly installed iProcess Engine. In this case, the default value is:
|
Machine ID |
Process |
Instance |
Value |
|
0 |
WIS |
0 |
28800 |
The default value gives a timeout period of 8 hours.
The attribute only appears in the output of the SHOW_ALL_ATTRIBUTES command if you have explicitly assigned a value to it using the SET_ATTRIBUTE command. The default setting is not displayed.