Checking DB Connectivity and Users
Edit the configuration items if needed and then enter C. The following prompt appears:
|
Checking DB connectivity and users ... |
The installer automatically checks the following items listed in Database-related Information Checklist to validate if it can create or upgrade the iProcess Engine database schema using the supplied information.
|
Item |
DBA-level access Required |
See |
|
NLS_LANG value |
No |
|
|
UNDO tablespace |
No |
|
|
TAF |
Yes |
|
|
OPEN_CURSORS value |
Yes |
|
|
Advanced Queuing configuration |
Yes |
|
|
Note: If you do not have the name and password of an Oracle DBA account, the installer cannot check the TAF, OPEN_CURSORS, and Advance Queuing configuration, so you need to check these items manually before proceeding. |
||
If the installer encounters any problems, it displays appropriate messages, error codes and/or further prompts. See:
| — | the relevant sections in Configuration Menus for TIBCO iProcess Engine Installation for information about additional prompts on specific menu items. |
| — | Troubleshooting for more information about other messages and prompts that may occur. |
After the installer checks the information listed in Database-related Information Checklist, the Configuration Summary page is display. Review the Configuration Summary and then start to install iProcess Engine. For detailed information, see Installing TIBCO iProcess Engine in Console Mode, step 6.