Using Configuration Menus

Each configuration menu has the following basic structure and controls:

Basic Structure

For a new installation, the menu structure is as follows:

Installing TIBCO iProcess® Engine Version 11.8.0
Menu Title
n.Menu Item:                       value
Enter Number of Item to Edit, (C)ontinue, (B)ack or (Q)uit:

For an upgrade installation, the menu structure is as follows:

Upgrading TIBCO iProcess Engine from Version PreviousRelease to Version 11.8.0
Menu Title
n. Menu Item                       : value
Enter Number of Item to Edit, (C)ontinue, (B)ack or (Q)uit:
Note: Only the new installation menus will be shown as the examples in this manual.

Basic Control

You can perform the following operations on each menu:

• If you want to change the value of a menu item, enter its number. A prompt for the new value is then displayed. If you want to leave the value unchanged, just press the ENTER key at this prompt.
Note: You cannot change the value of a menu item if it is preceded by an asterisk (*) instead of a number.
• Enter C to move to the next menu.
• Enter B to return to the previous menu.
• Enter Q if you want to quit the installation. The following prompt appears: 
Configuration information entered will be saved to the control file:

/TIBCO/iPE/swnod1/logs/swinstall.dat

Are you sure you want to quit this install ? (Y/N - default N):

Enter Y to quit the installation. The following prompt appears:

Exiting install. Configuration saved as /TIBCO/iPE/swnod1/logs/swinstall.dat

Configuration information entered will be saved to the control file /TIBCO/iPE/swnod1/logs/swinstall.dat, but any changes that you have made to the current menu are lost.

For more information about the swinstall.dat control file, see Control File.