Copyright © Cloud Software Group, Inc. All rights reserved.
Copyright © Cloud Software Group, Inc. All rights reserved.


Chapter 7 Administering Message Queues and Mbox Sets : Using SWDIR\util\swadm to Administer Mbox Sets, Message Queues and Messages : Add a Message Queue to an Mbox Set

Add a Message Queue to an Mbox Set
You can add or remove message queues to Mbox sets at any time to alter the Mbox set configuration. For example, you might want to increase the number of queues in an Mbox to handle a larger volume of messages.
You must explicitly create a queue before you can add it to an Mbox set. You can do this using the add_queue command.
To add a queue to an Mbox set, use the following command:
swadm add_queue_to_mboxset mboxset_id queue_id
where:
mboxset_id is the unique identifier for the Mbox set. You can find an Mbox set’s identifier using the show_mboxsets command.
queue_id is the unique identifier of the queue you want to add. You can find a queue’s identifier using the show_queues command.
The following example adds the queue BGMBOX3 to the BGMBSET Mbox set. (The show_mboxsets command is used first to identify the BGMBSET Mbox set’s mboxset_id, which is 1.)

 

 
 

Copyright © Cloud Software Group, Inc. All rights reserved.
Copyright © Cloud Software Group, Inc. All rights reserved.