Copyright © Cloud Software Group, Inc. All rights reserved.
Copyright © Cloud Software Group, Inc. All rights reserved.


Chapter 6 Administering Process Attributes : WIS and WQS Process Configuration : WIS_QCHANGE_EXTENDED_CHECK

WIS_QCHANGE_EXTENDED_CHECK
WIS and WQS Process Configuration
Summary
This attribute changes the behavior of a WIS process as to whether it counts changes to the lock status of work items as changes to the work items and work queues.
Applies To
The attribute can be set for a WIS process.
Permissible Values
The attribute value must be one of the following:
Default Value
This attribute is not defined on a newly installed iProcess Engine node. In this case, the default value is:
The attribute only appears in the output of the SHOW_ALL_ATTRIBUTES command if you have explicitly assigned a value to it using the SET_ATTRIBUTE command. The default setting is not displayed.
Notes
If this attribute is not set, changes to the lock status of work items are not counted as changes to queues for the purpose of monitoring changes in queues. This means that if a user just locks or keeps an item without making any other changes to a queue, then iProcess Objects or the SAL does not flag that any changes have been made to the queue, and even if the queue is refreshed, no changes are apparent.
If this attribute is set then the lock status is changed (the QPAR version number is updated and the OREC version number is incremented) in the following situations:
This allows iProcess Engine to detect these changes in the queue.
 

Copyright © Cloud Software Group, Inc. All rights reserved.
Copyright © Cloud Software Group, Inc. All rights reserved.