Copyright © Cloud Software Group, Inc. All rights reserved.

DISABLE_CASE_COUNTING

TIBCO iProcess Workspace (Windows) Configuration

Summary

This attribute defines whether case counts are displayed for procedures in the Live (Dead) Cases column of the Case Administrator dialog, when a user starts iProcess Administrator from iProcess Workspace (Windows).

Applies To

This attribute can be set for ALL processes.

Permissible Values

The attribute value must be one of the following:

Value	Meaning
0	The Live (Dead) Cases column is populated when the Case Administrator dialog loads.
1	The Live (Dead) Cases column is not populated when the Case Administrator dialog loads. This improves the dialog’s loading time.

Default Value

This attribute is not defined on a newly installed iProcess Engine node. In this case, the default value is:

Machine ID	Process	Instance	Value
0	ALL	0	0

The attribute only appears in the output of the SHOW_ALL_ATTRIBUTES command if you have explicitly assigned a value to it using the SET_ATTRIBUTE command. The default setting is not displayed

Notes

Normally, procedures are only displayed in the Case Administrator dialog if they have Case Administration access, have started cases, and the user is logged in to as either the procedure owner or an Administrator. However, when DISABLE_CASE_COUNTING=1, all procedures on the system are displayed in the Case Administrator dialog.

Copyright © Cloud Software Group, Inc. All rights reserved.