Subcase Information

Copyright © Cloud Software Group, Inc. All rights reserved.

Appendix F Using the plist Utility to Obtain Information About TIBCO iProcess Engine Facilities : Subcase Information

Subcase Information

Command

The following command returns the information about sub-cases:

plist -C [nodename] <procname>

Returns

The plist -C command returns the following information.

Column

Description

CNum

Case number.

CID

The case ID, which is a unique reference used internally by TIBCO iProcess Engine. It is sometimes referred to as a case control record number or CCR.

yyyy/ddd hh:mm

If the case status is Dead, the column displays the date and time when starting the case, otherwise it displays nothing.

Case Description

Information about the case.

Starter

User who started the case.

Example

Input the SWDIR/util/plist -C maintem command where maintem is the procedure name. The output is shown as follows.

CNum CID Sts Case Description Starter yyyy/ddd hh:mm

------------------------------------------------------------------

1 1 (null) -D- case1 swadmin@swnod012 2012/097 12:30

101 101 (null) -D- test2 swadmin@swnod012 2012/097 14:31

201 201 (null) --- test3 swadmin@swnod012 2012/097 14:33

Column	Description
CNum	Case number.
CID	The case ID, which is a unique reference used internally by TIBCO iProcess Engine. It is sometimes referred to as a case control record number or CCR.
yyyy/ddd hh:mm	If the case status is Dead, the column displays the date and time when starting the case, otherwise it displays nothing.
Case Description	Information about the case.
Starter	User who started the case.